Radar Vectors
FAA Order Current Issued Mar 21, 1975 AJM-322 1 pages Copy saved Nov 17, 2026

Order 6750.26 Obstruction Marking of ILS Glide Slope Antenna Towers

Official source ↗ Open PDF

DEPARTMENT OF TRANSPORTATION ORDER FEDERAL AVIATION ADMINISTRATION 6750. 26

DEPARTMENT OF TRANSPORTATION ORDER FEDERAL AVIATION ADMINISTRATION 6750. 26

3/2l/75

SUBJ: OBSTRUCTION MA~KING OF ILS GLIDE SLOPE ANTENNA TOWERS

1. PURPOSE. This order provides guidance on the obstruction marking requirements for ILS glide slope antenna towers.

2. DISTRIBUTION. This order is distributed to branch level in Airway Facilities, Air Traffic and Flight Standards Services within Washington and regional headquarters; to branch level at the FAA Depot and Airway Engineering Support Division at the Aeronautical Center; and to division level at NAFEC.

SUBJ: OBSTRUCTION MA~KING OF ILS GLIDE SLOPE ANTENNA TOWERS

3. BACKGROUND. ILS glide slope antenna towers are generally procured in five, ten, and/or twenty-foot sections with obstruction painting factory applied. These sections are erected in the field up to a maximum height of sixty feet. Sometimes, the tower sections are modified in the field to shorten the overall tower height somewhat to meet technical requirements needed to achieve the precise glide slope

angle required. As a result, the widths of the alternating bands of orange and white may be neither equal nor one-seventh of the tower height, and the top and/or bottom band may not be orange - as required by Advisory Circular AC 70/7460-lD, Obstruction Marking and Lighting.

4. OBSTRUCTION MARKING REQUIREMENT. The Air Traffic Service has approved a deviation from AC 70/7460-~to enable a more practical obstruction marking requirement for ILS glide slope antenna towers procured in sections of different heights and erected (and, sometimes, modified) in the field in various combinations, as follows:

a. ILS glide slope antenna towers shall be obstruction painted in

alternating bands of aviation orange and white.

b. There shall be a minimum of three bands with the top band aviation

orange.

c. The bands shall be no wider than fifteen feet nor less than one and

one-half feet.

,:---\d. At the first repainting of the towers, the obstruction marking ~~~be revised to conform with the AC 70/7460-W standards. f

t2ARREN C. SHARP . Director, Airway Facilities Service

Distribution: WRAF/AT/FS-3; CDE/AE-3; N-2 Initiated By: AA!il•S66 IIOP!- lf/Jo