Radar Vectors
Information for Operators Current Issued 2015 Flight Standards Service 2 pages Copy saved Nov 17, 2026

InFO 15007 Gates Products Not Designed or Intended for Aircraft Use

Official source ↗ Open PDF

Distributed by: Flight Standards

http://www.faa.gov/other_visit/aviation_industry/airline_operators/airline_safety/info/all_infos … An InFO contains valuable information for operators that should help them meet certain administrative, regulatory, or operational requirements, with relatively low urgency or impact on safety. This is a guidance document. Its content is not legally binding in its own right and will not be relied upon by the Department as a separate basis for affirmative enforcement action or other administrative penalty. Conformity with the guidance document is voluntary only. Nonconformity will not affect rights and obligations under existing statutes and regulations. Subject: Gates Products Not Designed or Intended for Aircraft Use. Purpose: This InFO serves to inform operators and repair facilities of potential failures of Gates products that are not designed for aviation use and are currently being used in multiple aviation applications. Background: An experimental amateur built Rotorway Exec 162-F helicopter, suffered substantial damage following an emergency landing attempt in a field.

During climb out, at approximately 300 feet altitude, the pilot heard a loud bang and experienced an immediate loss of power. The accident investigation and analysis determined that the main rotor belt experienced a crimp type failure. The aircraft was equipped with a cog belt drive system, which was installed in June of 2003 and a main drive belt which had 215.9 hours of operation at the time of the accident. The owner regularly conducted the required annual inspections of the aircraft and the pilot did not report any irregularities prior to the accident. Discussion: The main drive belt, manufactured by Gates, is a Poly Chain Belt with part number SMGT- 1792-62. During the accident investigation, several documents were reviewed for the probable cause of failure. The research identified the following:

1. The Rotorway Exec 162-F Maintenance Manual states, "replace the main drive belts at 500 hours of operation, or at 5 years, or on condition, whichever comes first." While the belt did

not reach its 500 hour recommended limit and the owner regularly conducted the proper annual inspections, the belt was far beyond the 5-year limit. 2. The Gates catalog has an "Aircraft Policy" in the "Information and Glossary" section that states, "WARNING! BE SAFE! Do not use Gates belts, pulleys or sprockets on aircraft propeller or rotor drive systems or in-flight accessory drives. Gates products are not designed or intended for aircraft use.''

3. The Gates "Synchronous Belt Failure Analysis Guide'' describes the type of belt failure as a "crimp" failure. The guide states, " ... belt crimping damage is most commonly associated with belt mishandling, inadequate belt installation tension, sub-minimal sprocket diameters, and/or

InFO

Information for Operators

U.S. Department of Transportation Federal Aviation Administration

InFO 15007 DATE: 06/15/15 Flight Standards Service

Washington, DC

Distributed by: Flight Standards

entry of foreign objects within the belt drive." Our inspection of the belt did not show evidence of damage to the belt due to foreign objects.

4. During further research, we have found similar belt failures with this type of aircraft and cog belt systems. The National Transportation Safety Board (NTSB) has a full narrative identifying one such accident on its website, refer to NTSB Identification: CEN14LA307. Recommended Action: Operators and repair facilities should familiarize themselves with the information contained within this InFO and with Gates Catalog Aircraft Policy in order to be aware of and reduce the risk of accidents caused by belts not intended for aircraft use. However, if Gates products are used, operators and repair facilities should be aware of main drive belt breaks on aircraft utilizing a hydraulic cog belt tensioner and the proper measurement of tension when the tensioner reaches the desired parameters and also adhere to the manufacturers recommended life limits and inspection cycles. Contact: Direct questions or comments regarding this InFO to the Aircraft Maintenance Division’s General Aviation Branch at (202) 267-1675 or via email at [email protected].