73 FR 14731 Airworthiness Directives; General Electric Company Aircraft Engines (GEAE) CT7-8A Turboshaft Engines
The FAA proposes to supersede an existing airworthiness directive (AD) for certain GEAE CT7-8A turboshaft engines. That AD currently requires initial and repetitive inspections of the electrical chip detectors for the No. 3 bearing. This proposed AD would require removing certain GEAE CT7-8A turboshaft engines within 6,200 cycles-since-new. This proposed AD results from investigation for the root causes of two failures of the No. 3 bearing. We are proposing this AD to prevent failure of the No. 3 bearing due to contamination by Aluminum Oxide, which could result in a possible dual in-flight shutdown of the engines.
This document is proposed. It may have been replaced. Check the official source before relying on it.
[Docket No. FAA-2006-24261; Directorate Identifier 2006-NE-12-AD] RIN 2120-AA64
Airworthiness Directives; General Electric Company Aircraft Engines (GEAE) CT7-8A Turboshaft Engines
AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).
ACTION: Notice of proposed rulemaking (NPRM).
Summary
SUMMARY: The FAA proposes to supersede an existing airworthiness directive (AD) for certain GEAE CT7-8A turboshaft engines. That AD currently requires initial and repetitive inspections of the electrical chip detectors for the No. 3 bearing. This proposed AD would require removing certain GEAE CT7-8A turboshaft engines within 6,200 cycles-since-new. This proposed AD results from investigation for the root causes of two failures of the No. 3 bearing. We are proposing this AD to prevent failure of the No. 3 bearing due to contamination by Aluminum Oxide, which could result in a possible dual in-flight shutdown of the engines.
Dates
DATES: We must receive any comments on this proposed AD by May 19, 2008.
ADDRESSES: Use one of the following addresses to comment on this proposed AD.
• Federal eRulemaking Portal: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
Addresses
• Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue, SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
• Fax: (202) 493-2251.
Contact General Electric Aircraft Engines CT7 Series Turboprop Engines, 1000 Western Ave., Lynn, MA 01910; telephone (781) 594-3140, fax (781) 594-4805, for the service information identified in this proposed AD.
For Further Information Contact
FOR FURTHER INFORMATION CONTACT: Christopher Richards, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: [email protected]; telephone (731) 238-7133; fax (781) 238-7199.
Supplementary Information
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments regarding this proposal. Send your comments to an address listed under ADDRESSES. Include "Docket No. FAA-2006-24261; Directorate Identifier 2006-NE-12-AD" in the subject line of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the proposed AD. We will consider all comments received by the closing date and may amend the proposed AD in light of those comments.
Comments Invited
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of the DMS Web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78) or you may visit http://www.regulations.gov.
Examining the AD Docket
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is the same as the Mail address provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
Discussion
Discussion
The FAA proposes to amend 14 CFR part 39 by superseding AD 2006-06-51, Amendment 39-14566 (71 FR 19627, April 17, 2006). That AD requires:
• Within 25 hours time-in-service after the effective date of that AD, inspecting the electrical chip detector assembly.
• Staggering the inspection intervals so the chip detectors on both engines on the same helicopter are not inspected at the same time.
• Thereafter, within 25 hours time-since-last inspection, performing a repetitive inspection, and
• If the chip detector assembly contains any bearing material, replacing the engine.
That AD was the result of two failures of the No. 3 bearing in GEAE CT7-8A turboshaft engines. That condition, if not corrected, could result in a possible dual in-flight shutdown of the engines.
Actions Since AD 2006-06-51 Was Issued
Actions Since AD 2006-06-51 Was Issued
Since we issued that AD, GEAE has developed new procedures for flushing Aluminum Oxide hard particle contamination from the air cavity of the engine structure's front frame after the manufacturing process and for assembling the No. 3 bearing to the engine. Based on that new flushing procedure, we are proposing to:
• Delete the requirements to inspect the electrical chip detector, and
• Require removing any engine that has a serial number (SN) listed in Table 1 of this proposed AD unless the front frame was flushed and the No. 3 bearing replaced, and
• Prohibit installing any engine that has a SN listed in Table 1 of this proposed AD unless the front frame was flushed and the No. 3 bearing replaced.
Relevant Service Information
Relevant Service Information
We have reviewed and approved the technical contents of GEAE Service Bulletin (SB) CT7-8 S/B 72-0017, dated October 18, 2007, that describes procedures for flushing the engine front frame and replacing the No. 3 bearing.
FAA's Determination and Requirements of the Proposed AD
FAA's Determination and Requirements of the Proposed AD
We have evaluated all pertinent information and identified an unsafe condition that is likely to exist or develop on other products of this same type design. For that reason, we are proposing this AD, which would require removing certain GEAE CT7-8A turboshaft engines, listed by SN in this proposed AD, from service within 6,200 cycles-since-new, and, after the effective date of the proposed AD, would prohibit installing certain GEAE CT7-8A turboshaft engines, listed by SN in this proposed AD.
Costs of Compliance
Costs of Compliance
We estimate that this proposed AD would affect 29 engines installed on helicopters of U.S. registry. We also estimate that it would take about 66.0 work-hours per engine to perform the proposed actions, and that the average labor rate is $80 per work-hour. Required parts would cost about $3,476 per engine. Based on these figures, we estimate the total cost of the proposed AD to U.S. operators to be $253,924
Authority for This Rulemaking
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, "General requirements." Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
Regulatory Findings
We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the proposed AD:
1. Is not a "significant regulatory action" under Executive Order 12866;
2. Is not a "significant rule" under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Would not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD. See the ADDRESSES section for a location to examine the regulatory evaluation.
List of Subjects in 14 CFR Part 39
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Under the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
§ 39.13 [Amended]
2. The FAA amends § 39.13 by removing Amendment 39-14566 (71 FR 19627, April 17, 2006) and by adding a new airworthiness directive to read as follows:
§ 39.13 [Amended]
General Electric Company Aircraft Engines: Docket No. FAA-2006-24261; Directorate Identifier 2006-NE-12-AD.
Comments Due Date
(a) The Federal Aviation Administration (FAA) must receive comments on this airworthiness directive (AD) action by May 19, 2008.
Affected ADs
(b) This AD supersedes AD 2006-06-51, Amendment 39-14566.
Applicability
Applicability
(c) This AD applies to General Electric Company Aircraft Engines (GEAE) CT7-8A turboshaft engines that have a serial number (SN) listed in Table 1 of this AD. These engines are installed on, but not limited to, Sikorsky S92 helicopters.
Table 1.--Affected Engines by Serial Number
-----------------------Engine Serial No.--------------------------------
-----------------------Engine Serial No.--------------------------------
947205 947228 947254
947206 947230 947255
947207 947232 947256
947208 947233 947258
947209 947235 947260
947210 947238 947261
947211 947240 947262
947212 947241 947263
947214 947242 947265
947215 947243 947266
947217 947244 947274
947218 947245 947277
947219 947247 947278
947220 947248 947279
947221 947249 947280
947223 947250 947284
947225 947253 947285
Unsafe Condition
Unsafe Condition
(d) This AD results from investigation for the root causes of two failures of the No. 3 bearing. We are issuing this AD to prevent failure of the No. 3 bearing due to contamination by Aluminum Oxide, which could result in a possible dual in-flight shutdown of the engines.
Compliance
Compliance
(e) You are responsible for having the actions required by this AD performed within the compliance times specified unless the actions have already been done.
(f) No further action is required if:
(1) Your engine has an SN that is not listed in Table 1 of this AD, or
(2) Your engine has an SN listed in Table 1 of this AD, but the engine log specifies that the front frame was flushed and the No. 3 bearing was replaced.
Engines With SNs Listed in Table 1 of This AD
Engines With SNs Listed in Table 1 of This AD
(g) For engines with an SN listed in Table 1 of this AD, within 6,200 cycles-since-new, remove engine from service.
Installation Prohibition
(h) After the effective date of this AD, do not install any engine that has an SN listed in Table 1 of this AD unless the front frame was flushed and the No. 3 bearing was replaced. GEAE Service Bulletin (SB) CT7-8 S/B 72-0017, dated October 18, 2007, contains information on flushing the front frame and replacing the No. 3 bearing.
Alternative Methods of Compliance
Alternative Methods of Compliance
(i) The Manager, Engine Certification Office, FAA, has the authority to approve alternative methods of compliance for this AD if requested using the procedures found in 14 CFR 39.19.
Related Information
(j) GEAE SB No. CT7-8 S/B 72-0017, dated October 18, 2007, pertains to the subject of this AD.
Related Information
(k) Contact Christopher Richards, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: [email protected]; telephone (731) 238-7133; fax (781) 238-7199, for more information about this AD.
Issued in Burlington, Massachusetts, on March 12, 2008. Robert J. Ganley, Acting Manager, Engine and Propeller Directorate, Aircraft Certification Service.