Radar Vectors
Proposed Rule Proposed Issued May 2, 2006 3 pages Copy saved Nov 17, 2026

71 FR 25793 Airworthiness Directives; Air Tractor, Inc. Models AT-602, AT-802, and AT-802A Airplanes

We propose to adopt a new airworthiness directive (AD) for all Air Tractor, Inc. Models AT-602, AT-802, and AT-802A airplanes. This proposed AD would require you to repetitively inspect the engine mount for any cracks, repair or replace any cracked engine mount, and report any cracks found to the FAA. This proposed AD results from reports of cracked engine mounts. We are proposing this AD to detect and correct cracks in the engine mount, which could result in failure of the engine mount. Such failure could lead to separation of the engine from the airplane.

This document is proposed. It may have been replaced. Check the official source before relying on it.

Official source ↗ Official PDF ↗

14 CFR Part 39

[Docket No. FAA-2006-24228; Directorate Identifier 2006-CE-22-AD] RIN 2120-AA64

Airworthiness Directives; Air Tractor, Inc. Models AT-602, AT-802, and AT-802A Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION: Notice of proposed rulemaking (NPRM).

Summary

SUMMARY: We propose to adopt a new airworthiness directive (AD) for all Air Tractor, Inc. Models AT-602, AT-802, and AT-802A airplanes. This proposed AD would require you to repetitively inspect the engine mount for any cracks, repair or replace any cracked engine mount, and report any cracks found to the FAA. This proposed AD results from reports of cracked engine mounts. We are proposing this AD to detect and correct cracks in the engine mount, which could result in failure of the engine mount. Such failure could lead to separation of the engine from the airplane.

Dates

DATES: We must receive comments on this proposed AD by June 27, 2006.

ADDRESSES: Use one of the following addresses to comment on this proposed AD:

• DOT Docket Web site: Go to http://dms.dot.gov and follow the instructions for sending your comments electronically.

• Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.

Addresses

• Mail: Docket Management Facility; U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC 20590-0001.

• Fax: (202) 493-2251.

• Hand Delivery: Room PL-401 on the plaza level of the Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this proposed AD, contact Air Tractor, Inc., P.O. Box 485, Olney, Texas 76374; telephone: (940) 564-5616; facsimile: (940) 564-5612.

For Further Information Contact

FOR FURTHER INFORMATION CONTACT: Andrew McAnaul, Aerospace Engineer, ASW-150 (c/o MIDO-43), 10100 Reunion Place, Suite 650, San Antonio, Texas 78216; telephone: (210) 308-3365; facsimile: (210) 308-3370.

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments regarding this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include the docket number, "FAA-2006-24228; Directorate Identifier 2006-CE-22-AD" at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the proposed AD. We will consider all comments received by the closing date and may amend the proposed AD in light of those comments.

Comments Invited

We will post all comments we receive, without change, to http://dms.dot.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive concerning this proposed AD.

Discussion

We received two reports from Air Tractor, Inc. of cracked engine mounts resulting from fatigue. One report was for a Model AT-602 airplane. The specific airplane model with the other crack is unverified. This AD applies to Air Tractor, Inc. Models AT-602, AT-802, and AT-802A airplanes due to design similarity.

Discussion

A cracked engine mount, if not detected and corrected, could result in failure of the engine mount. Such failure could lead to separation of the engine from the airplane.

Relevant Service Information

We have reviewed Snow Engineering Co. Service Letter 253, dated December 12, 2005.

Relevant Service Information

The service information describes procedures for performing a visual inspection for cracks of the engine mount and requesting a repair scheme from the manufacturer.

Snow Engineering Co. has a licensing agreement with Air Tractor, Inc. that allows them to produce technical data to use for Air Tractor, Inc. products.

FAA's Determination and Requirements of the Proposed AD

FAA's Determination and Requirements of the Proposed AD

We are proposing this AD because we evaluated all information and determined the unsafe condition described previously is likely to exist or develop on other products of the same type design. This proposed AD would require you to repetitively inspect the engine mount for any cracks, repair or replace any cracked engine mount, and report any cracks found to the FAA. To repair a cracked engine mount, you would obtain an FAA-approved repair scheme from Air Tractor, Inc. following the instructions in the service information.

Costs of Compliance

Costs of Compliance

We estimate that this proposed AD would affect 368 airplanes in the U.S. registry.

We estimate the following costs to do the proposed inspection of the engine mount for cracks:

Total cost per

Labor cost Parts cost airplane per Total cost on U.S. operators for

inspection initial inspection

1.5 work hours x $80 per hour = Not Applicable … $120 368 x $120 = $44,160

$120.

We have no way of determining the number of airplanes that may need repair/replacement of the engine mount as a result of the proposed inspection. We have no way of determining the cost of an engine mount repair. To replace the engine mount would take 81 work hours at $80 per hour (estimated total labor = $6,480), parts cost of $3,982, and a total replacement cost of $10,462 per airplane.

Authority for This Rulemaking

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, "General requirements." Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

Regulatory Findings

We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that the proposed regulation:

1. Is not a "significant regulatory action" under Executive Order 12866;

2. Is not a "significant rule" under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.

Examining the AD Docket

Examining the AD Docket

You may examine the AD docket that contains the proposed AD, the regulatory evaluation, any comments received, and other information on the Internet at http://dms.dot.gov; or in person at the Docket Management Facility between 9 a.m. and 5:00 p.m., Monday through Friday, except Federal holidays. The Docket Office (telephone (800) 647-5227) is located at the street address stated in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

PART 39--AIRWORTHINESS DIRECTIVES

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13 [Amended]

2. The FAA amends § 39.13 by adding the following new AD:

Air Tractor, Inc.: Docket No. FAA-2006-24228; Directorate Identifier 2006-CE-22-AD.

Comments Due Date

(a) We must receive comments on this proposed airworthiness directive (AD) action by June 27, 2006.

Affected ADs

Affected ADs

(b) None.

Applicability

(c) This AD affects all Models AT-602, AT-802, and AT-802A airplanes, all serial numbers, that are certificated in any category.

Unsafe Condition

(d) This AD results from reports of cracked engine mounts. We are issuing this AD to detect and correct cracks in the engine mount, which could result in failure of the engine mount. Such failure could lead to separation of the engine from the airplane.

What Must I do to Address This Problem?

What Must I do to Address This Problem?

(e) To address this problem, you must do the following:

Actions Compliance Procedures

(1) Visually inspect the Initially inspect Follow Snow

engine mount for any cracks. upon accumulating Engineering Co.

4,000 hours time-in- Service Letter

service (TIS) or 253, dated

within the next 100 December 12, 2005.

hours TIS after the

effective date of

this AD, whichever

occurs later,

unless already

done. Thereafter,

repetitively

inspect every 300

hours TIS.

(2) If you find any crack Before further For obtaining a

damage, do one of the flight after any repair scheme:

following: inspection required Follow Snow

(i) Obtain an FAA-approved by paragraph (e)(1) Engineering Co.

repair scheme from the of this AD where Service Letter

manufacturer and crack damage is 253, dated

incorporate this repair found. If you December 12, 2005.

scheme; or repair the cracked For the

(ii) Replace the engine engine mount, then replacement: The

mount with a new engine continue to maintenance manual

mount. reinspect at includes

intervals not to instructions for

exceed 300 hours the replacement.

TIS, unless the

repair scheme

states differently.

If you replace the

engine mount, then

initially inspect

upon accumulating

4,000 hours TIS and

repetitively at

intervals not to

exceed 300 hours

TIS.

(3) Report any cracks that Within the next 10 The Office of

you find to the FAA at the days after you find Management and

address specified in the cracks or Budget (OMB)

paragraph (f) of this AD. within the next 10 approved the

Include in your report: days after the information

(i) Airplane serial number; effective date of collection

(ii) Airplane and engine this AD, whichever requirements

mount hours TIS; occurs later. contained in this

(iii) Crack location(s) and regulation under

size(s); the provisions of

(iv) Corrective action the Paperwork

taken; and Reduction Act of

(v) Point of contact name 1980 (44 U.S.C.

and telephone number 3501 et seq.) and

assigned OMB

Control Number 2120-

0056.

Alternative Methods of Compliance (AMOCs)

Alternative Methods of Compliance (AMOCs)

(f) The Manager, Fort Worth Airplane Certification Office, FAA, ATTN: Andrew McAnaul, Aerospace Engineer, ASW-150 (c/o MIDO-43), 10100 Reunion Place, Suite 650, San Antonio, Texas 78216; telephone: (210) 308-3365; facsimile: (210) 308-3370, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19.

Related Information

Related Information

(g) To get copies of the documents referenced in this AD, contact Air Tractor Inc., P.O. Box 485, Olney, Texas 76374; telephone: (940) 564-5616; facsimile: (940) 564-5612. To view the AD docket, go to the Docket Management Facility; U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC, or on the Internet at http://dms.dot.gov. The docket number is Docket No. FAA-2006-24228; Directorate Identifier 2006-CE-22-AD.

Issued in Kansas City, Missouri, on April 26, 2006. John R. Colomy, Acting Manager, Small Airplane Directorate, Aircraft Certification Service.