Radar Vectors
Final Rule Current Issued Jul 25, 2011 2 pages Copy saved Nov 17, 2026

76 FR 44245 Special Conditions: Gulfstream Model GVI Airplane; Limit Engine Torque Loads for Sudden Engine Stoppage

These special conditions are for the Gulfstream GVI airplane.

Official source ↗ Official PDF ↗

and Regulations DEPARTMENT OF TRANSPORTATION

14 CFR Part 25

[Docket No. NM454 Special Conditions No. 25-441-SC]

Special Conditions: Gulfstream Model GVI Airplane; Limit Engine

Torque Loads for Sudden Engine Stoppage

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final special conditions.

Summary

SUMMARY: These special conditions are for the Gulfstream GVI airplane.

This airplane has novel or unusual design features when compared to the

state of technology envisioned in the airworthiness standards for

transport category airplanes. These design features include engine size

and the potential torque load imposed by sudden engine stoppage. These

and the potential torque load imposed by sudden engine stoppage. These

special conditions pertain to their effects on the structural

performance of the airplane. The applicable airworthiness regulations

do not contain adequate or appropriate safety standards for these

design features. These special conditions contain the additional safety

standards that the Administrator considers necessary to establish a

standards that the Administrator considers necessary to establish a

level of safety equivalent to that established by the existing

airworthiness standards.

DATES: Effective Date: August 24, 2011.

FOR FURTHER INFORMATION CONTACT: Carl Niedermeyer, FAA, Airframe/Cabin

Safety Branch, ANM-115, Transport Standards Staff, Transport Airplane

Safety Branch, ANM-115, Transport Standards Staff, Transport Airplane

Directorate, Aircraft Certification Service, 1601 Lind Avenue, SW.,

Renton, Washington 98057-3356; telephone (425) 227-2279; electronic

mail [email protected].

SUPPLEMENTARY INFORMATION:

Background

On March 29, 2005, Gulfstream Aerospace Corporation (hereafter

referred to as "Gulfstream") applied for an FAA type certificate for

its new Gulfstream Model GVI passenger airplane. Gulfstream later

its new Gulfstream Model GVI passenger airplane. Gulfstream later

applied for, and was granted, an extension of time for the type

certificate, which changed the effective application date to September

28, 2006. The Gulfstream Model GVI airplane will be an all-new, two-

engine jet transport airplane with an executive cabin interior. The

maximum takeoff weight will be 99,600 pounds, with a maximum passenger

maximum takeoff weight will be 99,600 pounds, with a maximum passenger

count of 19 passengers.

Type Certification Basis

Under provisions of Title 14, Code of Federal Regulations (14 CFR)

21.17, Gulfstream must show that the Gulfstream Model GVI airplane

(hereafter referred to as "the GVI") meets the applicable provisions

of 14 CFR part 25, as amended by Amendments 25-1 through 25-119, 25-

of 14 CFR part 25, as amended by Amendments 25-1 through 25-119, 25-

122, and 25-124. If the Administrator finds that the applicable

airworthiness regulations (i.e., 14 CFR part 25) do not contain

adequate or appropriate safety standards for the GVI because of a novel

or unusual design feature, special conditions are prescribed under the

or unusual design feature, special conditions are prescribed under the

provisions of § 21.16.

Special conditions are initially applicable to the model for which

they are issued. Should the type certificate for that model be amended

later to include any other model that incorporates the same novel or

unusual design features, the special conditions would also apply to the

unusual design features, the special conditions would also apply to the

other model under provisions of § 21.101.

In addition to complying with the applicable airworthiness

regulations and special conditions, the GVI must comply with the fuel

vent and exhaust emission requirements of 14 CFR part 34 and the noise

certification requirements of 14 CFR part 36. The FAA must also issue a

finding of regulatory adequacy pursuant to section 611 of Public Law

finding of regulatory adequacy pursuant to section 611 of Public Law

92-574, the "Noise Control Act of 1972."

The FAA issues special conditions, as defined in 14 CFR 11.19, in

accordance with § 11.38, and they become part of the type

certification basis under § 21.17(a)(2).

Novel or Unusual Design Features

Novel or Unusual Design Features

The GVI will have high bypass engines. Engines of this size,

configuration, and failure modes were not envisioned when § 25.361,

which addresses loads imposed by engine seizure, was adopted in 1965.

Worst case engine seizure events have become increasingly more severe

with increasing engine size because of the higher inertia of the

rotating components. The GVI engines are sufficiently different and

rotating components. The GVI engines are sufficiently different and

novel to justify issuance of a special condition to establish

appropriate design standards.

Discussion of Special Conditions

Section 25.361(b)(1) requires that for turbine engine

installations, the engine mounts and the supporting structures must be

designed to withstand a "limit engine torque load imposed by sudden

designed to withstand a "limit engine torque load imposed by sudden

engine stoppage due to malfunction or structural failure." Limit loads

are expected to occur about once in the lifetime of any airplane.

Section 25.305 requires that supporting structures be able to support

limit loads without detrimental permanent deformation, meaning that

supporting structures should remain serviceable after a limit load

supporting structures should remain serviceable after a limit load

event.

Since adoption of § 25.361(b)(1), the size, configuration, and

failure modes of jet engines have changed considerably. Current engines

are much larger and are designed with large bypass fans. In the event

of a structural failure, these engines are capable of producing much

of a structural failure, these engines are capable of producing much

higher transient loads on the engine mounts and supporting structures.

As a result, modern high bypass engines are subject to certain

rare-but-severe engine seizure events. Service history shows that such

events occur far less frequently than limit load events. Although it is

important for the airplane to be able to support such rare loads safely

without failure, it is unrealistic to expect that no permanent

without failure, it is unrealistic to expect that no permanent

deformation will occur.

Given this situation, the Aviation Rulemaking Advisory Committee

(ARAC) has proposed a design standard for today's large engines. For

the commonly-occurring deceleration events, the proposed standard would

require engine mounts and structures to support maximum torques without

require engine mounts and structures to support maximum torques without

detrimental permanent deformation. For the rare-but-severe engine

seizure events such as loss of any fan, compressor, or turbine blade, the proposed standard would require engine mounts and

structures to support maximum torques without failure, but allows for

structures to support maximum torques without failure, but allows for

some deformation in the structure.

The FAA concludes that modern large engines, including those on the

GVI, are novel and unusual compared to those envisioned when Sec.

25.361(b)(1) was adopted and thus warrant special conditions. The

special conditions contain design criteria recommended by ARAC. The

special conditions also clarify the design criteria that apply to

special conditions also clarify the design criteria that apply to

auxiliary power units.

Discussion of Comments

Notice of proposed special conditions No. 25-11-11-SC for

Gulfstream GVI airplanes was published in the Federal Register on May

5, 2011 (76 FR 25648). One supportive comment was received and the

5, 2011 (76 FR 25648). One supportive comment was received and the

special conditions are adopted as proposed.

Applicability

As discussed above, these special conditions are applicable to the

GVI. Should Gulfstream apply at a later date for a change to the type

certificate to include another model incorporating the same novel or

unusual design features, these special conditions would apply to that

unusual design features, these special conditions would apply to that

model as well.

Conclusion

This action affects only certain novel or unusual design features

of the GVI. It is not a rule of general applicability.

List of Subjects in 14 CFR Part 25

Aircraft, Aviation safety, Reporting and recordkeeping

requirements.

The authority citation for these special conditions is as follows:

List of Subjects in 14 CFR Part 25

Authority: 49 U.S.C. 106(g), 40113, 44701, 44702, 44704.

The Special Conditions

Accordingly, pursuant to the authority delegated to me by the

Administrator, the following special conditions are issued as part of

the type certification basis for Gulfstream GVI airplanes.

The following special conditions are in lieu of § 25.361(b):

Administrator, the following special conditions are issued as part of

1. For turbine engine installations, the engine mounts, pylons and

adjacent supporting airframe structure must be designed to withstand 1g

level flight loads acting simultaneously with the maximum limit torque

loads imposed by each of the following:

(a) Sudden engine deceleration due to a malfunction which could

result in a temporary loss of power or thrust; and

result in a temporary loss of power or thrust; and

(b) The maximum acceleration of the engine.

2. For auxiliary power unit installations, the power unit mounts

and adjacent supporting airframe structure must be designed to

withstand 1g level flight loads acting simultaneously with the maximum

withstand 1g level flight loads acting simultaneously with the maximum

limit torque loads imposed by each of the following:

(a) Sudden auxiliary power unit deceleration due to malfunction or

structural failure; and

(b) The maximum acceleration of the power unit.

3. For engine supporting structure, an ultimate loading condition

must be considered that combines 1g flight loads with the transient

must be considered that combines 1g flight loads with the transient

dynamic loads resulting from:

(a) The loss of any fan, compressor, or turbine blade; and

(b) Separately, where applicable to a specific engine design, any

other engine structural failure that results in higher loads.

4. The ultimate loads developed from the conditions specified in

paragraphs 3(a) and 3(b) are to be multiplied by a factor of 1.0 when

paragraphs 3(a) and 3(b) are to be multiplied by a factor of 1.0 when

applied to engine mounts and pylons and multiplied by a factor of 1.25

when applied to adjacent supporting airframe structure.

5. Any permanent deformation that results from the conditions

specified in paragraph 3 must not prevent continued safe flight and

specified in paragraph 3 must not prevent continued safe flight and

landing.

Issued in Renton, Washington, on July 18, 2011.

Ali Bahrami,

Manager, Transport Airplane Directorate, Aircraft Certification

Service.