Radar Vectors
Airworthiness Directive Current Issued Jun 8, 2010 2 pages Copy saved Nov 17, 2026

AD 2010-12-03 CFM International, S.A. Models CFM56-3 and -3B Turbofan Engines

The FAA is adopting a new airworthiness directive (AD) for

Official source ↗ Official PDF ↗

14 CFR Part 39

[Docket No. FAA-2009-0606; Directorate Identifier 2009-NE-11-AD;

Amendment 39-16324; AD 2010-12-03]

RIN 2120-AA64

Airworthiness Directives; CFM International, S.A. Models CFM56-3

and -3B Turbofan Engines

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule.

Summary

SUMMARY: The FAA is adopting a new airworthiness directive (AD) for

certain CFM International, S.A. models CFM56-3 and -3B turbofan

engines. This AD requires initial and repetitive inspections for damage

to the fan blades. This AD results from a report of a failed fan blade

with severe out-of-limit wear on the underside of the blade platform

where it contacts the damper. We are issuing this AD to prevent failure

where it contacts the damper. We are issuing this AD to prevent failure

of multiple fan blades, which could result in an uncontained failure of

the engine and damage to the airplane.

DATES: This AD becomes effective July 13, 2010. The Director of the

Federal Register approved the incorporation by reference of certain

Federal Register approved the incorporation by reference of certain

publications listed in the regulations as of July 13, 2010.

ADDRESSES: You can get the service information identified in this AD

from CFM International, S. A., Technical Publication Department, 1

Neumann Way, Cincinnati, OH 45215; telephone (513) 552-2800; fax (513)

552-2816.

The Docket Operations office is located at Docket Management

Neumann Way, Cincinnati, OH 45215; telephone (513) 552-2800; fax (513)

Facility, U.S. Department of Transportation, 1200 New Jersey Avenue,

SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-

0001.

FOR FURTHER INFORMATION CONTACT: Antonio Cancelliere, Aerospace

Engineer, Engine Certification Office, FAA, Engine & Propeller

Directorate, 12 New England Executive Park, Burlington, MA 01803; e-

mail: [email protected]; telephone (781) 238-7751; fax (781)

mail: [email protected]; telephone (781) 238-7751; fax (781)

238-7199.

SUPPLEMENTARY INFORMATION: The FAA proposed to amend 14 CFR part 39

with a proposed AD. The proposed AD applies to certain CFM

International, S.A. models CFM56-3 and -3B turbofan engines. We

published the proposed AD in the Federal Register on July 23, 2009 (74

FR 36420), and published a supplemental proposed AD in the Federal

FR 36420), and published a supplemental proposed AD in the Federal

Register on April 1, 2010 (75 16361). Those actions proposed to require

initial and repetitive inspections for damage to the fan blades.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office

between 9 a.m. and 5 p.m., Monday through Friday, except Federal

between 9 a.m. and 5 p.m., Monday through Friday, except Federal

holidays. The AD docket contains this AD, the regulatory evaluation,

any comments received, and other information. The street address for

the Docket Operations office (telephone (800) 647-5527) is provided in

the ADDRESSES section. Comments will be available in the AD docket

the ADDRESSES section. Comments will be available in the AD docket

shortly after receipt.

Comments

We provided the public the opportunity to participate in the

development of this AD. We previously responded to the comments

received on the original proposed AD in the supplemental proposed AD.

We have considered the one comment received on the supplemental

We have considered the one comment received on the supplemental

proposed AD. The commenter supports the proposal.

Conclusion

We have carefully reviewed the available data, including the

comment received, and determined that air safety and the public

interest require adopting the AD as proposed.

Costs of Compliance

We estimate that this AD will affect 50 engines installed on

airplanes of U.S. registry. We also estimate that it will take about 8

airplanes of U.S. registry. We also estimate that it will take about 8

work-hours per engine to perform the AD actions, and that the average

labor rate is $80 per work-hour. Required parts will cost about $38,000

per engine. Based on these figures, we estimate the total cost of the

per engine. Based on these figures, we estimate the total cost of the

AD to U.S. operators to be $1,932,000.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to

issue rules on aviation safety. Subtitle I, section 106, describes the

authority of the FAA Administrator. Subtitle VII, Aviation Programs,

describes in more detail the scope of the Agency's authority.

issue rules on aviation safety. Subtitle I, section 106, describes the

We are issuing this rulemaking under the authority described in

subtitle VII, part A, subpart III, section 44701, "General

requirements." Under that section, Congress charges the FAA with

promoting safe flight of civil aircraft in air commerce by prescribing

regulations for practices, methods, and procedures the Administrator

finds necessary for safety in air commerce. This regulation is within

finds necessary for safety in air commerce. This regulation is within

the scope of that authority because it addresses an unsafe condition

that is likely to exist or develop on products identified in this

rulemaking action.

Regulatory Findings

We have determined that this AD will not have federalism

implications under Executive Order 13132. This AD will not have a

implications under Executive Order 13132. This AD will not have a

substantial direct effect on the States, on the relationship between

the national government and the States, or on the distribution of power

and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

the national government and the States, or on the distribution of power

(1) Is not a "significant regulatory action" under Executive

Order 12866;

(2) Is not a "significant rule" under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and

(3) Will not have a significant economic impact, positive or

negative, on a substantial number of small entities under the criteria

negative, on a substantial number of small entities under the criteria

of the Regulatory Flexibility Act.

We prepared a summary of the costs to comply with this AD and

placed it in the AD Docket. You may get a copy of this summary at the

address listed under ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

List of Subjects in 14 CFR Part 39

reference, Safety.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator,

the Federal Aviation Administration amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

PART 39--AIRWORTHINESS DIRECTIVES

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13 [Amended]

2. The FAA amends § 39.13 by adding the following new airworthiness

directive:

2010-12-03 CFM International, S.A.: Amendment 39-16324. Docket No.

FAA-2009-0606; Directorate Identifier 2009-NE-11-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective July 13,

Effective Date

2010.

Affected ADs

(b) None.

Applicability

(c) This AD applies to CFM International, S.A. models CFM56-3

and -3B turbofan engines with 25 degrees midspan shroud fan blades,

part numbers (P/Ns) 9527M99P08, 9527M99P09, 9527M99P10, 9527M99P11,

1285M39P01, or fan blade pairs, P/Ns 335-088-901-0, 335-088-902-0,

335-088-903-0, and 335-088-904-0 installed. These engines are

335-088-903-0, and 335-088-904-0 installed. These engines are

installed on, but not limited to, Boeing 737 series airplanes.

(d) CFM International, S.A. has added to the basic engine model

number on the engine nameplate to identify minor variations in

engine configuration, installation components, or reduced ratings

engine configuration, installation components, or reduced ratings

peculiar to aircraft installation requirements.

(e) Those engines marked on the engine data plate as CFM56-3-B1

are included in this AD as CFM56-3 turbofan engines.

(f) Those engines marked on the engine data plate as CFM56-3B-2

are included in this AD as CFM56-3B turbofan engines.

Unsafe Condition

Unsafe Condition

(g) This AD results from a report of a failed fan blade with

severe out-of-limit wear on the underside of the blade platform

where it contacts the damper. We are issuing this AD to prevent

failure of multiple fan blades, which could result in an uncontained

failure of the engine and damage to the airplane.

Compliance

Compliance

(h) You are responsible for having the actions required by this

AD performed within the compliance times specified, unless the

actions have already been done.

Inspection for Wear

(i) Within 900 cycles-in-service after the effective date of

this AD, perform an on-wing or in-shop inspection of the fan blade

and damper for wear. Use paragraphs 3.A.(1) through 3.A.(5) or

and damper for wear. Use paragraphs 3.A.(1) through 3.A.(5) or

paragraphs 3.B.(1) through 3.B.(5) respectively, of the

Accomplishment Instructions of CFM International Service Bulletin

(SB) No. CFM56-3/3B/3C S/B 72-1067, dated February 15, 2007.

(j) If you find out-of-limit wear on at least one fan blade

platform underside, perform the additional inspections and

platform underside, perform the additional inspections and

disposition the parts, as specified in paragraphs 3.A.(3) and

3.A.(5) or paragraphs 3.B.(3) and 3.B.(5) respectively, of the

Accomplishment Instructions of CFM International SB No. CFM56-3/3B/

3C S/B 72-1067, dated February 15, 2007.

Accomplishment Instructions of CFM International SB No. CFM56-3/3B/

(k) Thereafter, within intervals not to exceed 3,000 cycles-

since-last inspection, perform an on-wing or in-shop inspection for

wear. Use paragraphs 3.A.(1) through 3.A.(5) or paragraphs 3.B.(1)

through 3.B.(5) respectively, of the Accomplishment Instructions of

CFM International SB No. CFM56-3/3B/3C S/B 72-1067, dated February

CFM International SB No. CFM56-3/3B/3C S/B 72-1067, dated February

15, 2007.

(l) If you find wear on at least one fan blade platform

underside, perform additional inspections and disposition the parts,

as specified in paragraphs 3.A.(3) and 3.A.(5) or paragraphs 3.B.(3)

and 3.B.(5) respectively, of the Accomplishment Instructions of CFM

International SB No. CFM56-3/3B/3C S/B 72-1067, dated February 15,

and 3.B.(5) respectively, of the Accomplishment Instructions of CFM

2007.

Installation Prohibition

(m) After the effective date of this AD, don't install any 25

degrees midspan shroud fan blades, P/Ns 9527M99P08, 9527M99P09,

9527M99P10, 9527M99P11, 1285M39P01, or fan blade pairs, P/Ns 335-

088-901-0, 335-088-902-0, 335-088-903-0, and 335-088-904-0, unless

they have passed an inspection specified in paragraph 3. of the

they have passed an inspection specified in paragraph 3. of the

Accomplishment Instructions of CFM International SB No. CFM56-3/3B/

3C S/B 72-1067, dated February 15, 2007.

Optional Terminating Action

(n) Replacing the 25 degrees midspan shroud fan blade set with a

37 degrees midspan shroud fan blade set terminates the repetitive

37 degrees midspan shroud fan blade set terminates the repetitive

inspection requirements specified in paragraph (k) of this AD.

Alternative Methods of Compliance

(o) The Manager, Engine Certification Office, has the authority

to approve alternative methods of compliance for this AD if

requested using the procedures found in 14 CFR 39.19.

Related Information

Related Information

(p) Contact Antonio Cancelliere, Aerospace Engineer, Engine

Certification Office, FAA, Engine & Propeller Directorate, 12 New

England Executive Park, Burlington, MA 01803; e-mail:

[email protected]; telephone (781) 238-7751; fax (781)

238-7199, for more information about this AD.

[email protected]; telephone (781) 238-7751; fax (781)

(q) European Aviation Safety Agency AD 2009-0036, dated February

20, 2009, also addresses the subject of this AD.

Material Incorporated by Reference

(r) You must use CFM International Service Bulletin No. CFM56-3/

3B/3C S/B 72-1067, dated February 15, 2007, to perform the

inspections and parts dispositions required by this AD. The Director

of the Federal Register approved the incorporation by reference of

of the Federal Register approved the incorporation by reference of

this service bulletin in accordance with 5 U.S.C. 552(a) and 1 CFR

part 51. Contact CFM International, S. A., Technical Publication

Department, 1 Neumann Way, Cincinnati, OH 45215; telephone (513)

552-2800; fax (513) 552-2816, for a copy of this service

552-2800; fax (513) 552-2816, for a copy of this service

information. You may review copies at the FAA, New England Region,

12 New England Executive Park, Burlington, MA; or at the National

Archives and Records Administration (NARA). For information on the

availability of this material at NARA, call 202-741-6030, or go to:

http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Archives and Records Administration (NARA). For information on the

Issued in Burlington, Massachusetts, on May 25, 2010.

Peter A. White,

Assistant Manager, Engine and Propeller Directorate, Aircraft

Certification Service.