Radar Vectors
Airworthiness Directive Current Issued Jun 8, 2010 3 pages Copy saved Nov 17, 2026

AD 2010-12-02 Turbomeca S.A. MAKILA 1A and 1A1 Turboshaft Engines

We are adopting a new airworthiness directive (AD) for the

Official source ↗ Official PDF ↗

14 CFR Part 39

[Docket No. FAA-2009-0982; Directorate Identifier 2009-NE-19-AD;

Amendment 39-16323; AD 2010-12-02]

RIN 2120-AA64

Airworthiness Directives; Turbomeca S.A. MAKILA 1A and 1A1

Turboshaft Engines

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule.

SUMMARY: We are adopting a new airworthiness directive (AD) for the

products listed above. This AD results from mandatory continuing

products listed above. This AD results from mandatory continuing

airworthiness information (MCAI) issued by an aviation authority of

another country to identify and correct an unsafe condition on an

aviation product. The MCAI describes the unsafe condition as:

The installation of TU250 comparator/selector (CS) boards,

however, has resulted in a few occurrences of erratic engine

however, has resulted in a few occurrences of erratic engine

behaviour, in the form of unexpected N1 variations and/or

illumination of the "GOV" warning light. The conclusions from an

investigation by Turboméca are that these malfunctions are

due to a lapse of quality control in the varnishing process applied

to the boards, and that only boards in a specific serial number

to the boards, and that only boards in a specific serial number

range, as defined under "Applicability" and referred to below as

the "suspect batch", are affected.

We are issuing this AD to prevent loss of automatic engine control

during flight due to an uncommanded engine roll-back, which could

during flight due to an uncommanded engine roll-back, which could

result in the inability to continue safe flight.

DATES: This AD becomes effective July 13, 2010. The Director of the

Federal Register approved the incorporation by reference of certain

publications listed in this AD as of July 13, 2010.

ADDRESSES: The Docket Operations office is located at Docket Management

Addresses

Facility, U.S. Department of Transportation, 1200 New Jersey Avenue,

SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-

0001.

FOR FURTHER INFORMATION CONTACT: Kevin Dickert, Aerospace Engineer,

Engine Certification Office, FAA, Engine and Propeller Directorate, 12

Engine Certification Office, FAA, Engine and Propeller Directorate, 12

New England Executive Park, Burlington, MA 01803; e-mail:

[email protected]; telephone (781) 238-7117, fax (781) 238-7199.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR

part 39 to include an AD that would apply to the specified products.

That NPRM was published in the Federal Register on March 31, 2010 (75

That NPRM was published in the Federal Register on March 31, 2010 (75

FR 16022). That NPRM proposed to correct an unsafe condition for the

specified products. The MCAI states that:

The installation of TU250 CS boards, however, has resulted in a

few occurrences of erratic engine behaviour, in the form of

unexpected N1 variations and/or illumination of the "GOV" warning

unexpected N1 variations and/or illumination of the "GOV" warning

light. The conclusions from an investigation by Turbomeca are that

these malfunctions are due to a lapse of quality control in the

varnishing process applied to the boards, and that only boards in a

specific serial number range, as defined under "Applicability" and

specific serial number range, as defined under "Applicability" and

referred to below as the "suspect batch", are affected.

Comments

We gave the public the opportunity to participate in developing

this AD. We received no comments on the NPRM or on the determination of

the cost to the public.

Conclusion

We reviewed the available data and determined that air safety and

Conclusion

the public interest require adopting the AD as proposed.

Costs of Compliance

Based on the service information, we estimate that this AD will

affect about 10 products of U.S. registry. We also estimate that it

will take about 1 work-hour per product to comply with this AD. The

average labor rate is $85 per work-hour. Required parts will cost about

$3,500 per product. Based on these figures, we estimate the cost of the

$3,500 per product. Based on these figures, we estimate the cost of the

AD on U.S. operators to be $35,850.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to

issue rules on aviation safety. Subtitle I, section 106, describes the

authority of the FAA Administrator. "Subtitle VII: Aviation

Programs," describes in more detail the scope of the Agency's

Programs," describes in more detail the scope of the Agency's

authority.

We are issuing this rulemaking under the authority described in

"Subtitle VII, Part A, Subpart III, Section 44701: General

requirements." Under that section, Congress charges the FAA with

promoting safe flight of civil aircraft in air commerce by prescribing

regulations for practices, methods, and procedures the Administrator

regulations for practices, methods, and procedures the Administrator

finds necessary for safety in air commerce. This regulation is within

the scope of that authority because it addresses an unsafe condition

that is likely to exist or develop on products identified in this

rulemaking action.

Regulatory Findings

Regulatory Findings

We determined that this AD will not have federalism implications

under Executive Order 13132. This AD will not have a substantial direct

effect on the States, on the relationship between the national

government and the States, or on the distribution of power and

government and the States, or on the distribution of power and

responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

1. Is not a "significant regulatory action" under Executive Order

12866;

2. Is not a "significant rule" under the DOT Regulatory Policies

and Procedures (44 FR 11034, February 26, 1979); and

and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or

negative, on a substantial number of small entities under the criteria

of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to

comply with this AD and placed it in the AD docket.

Examining the AD Docket

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office

between 9 a.m. and 5 p.m., Monday through Friday, except Federal

holidays. The AD docket contains this AD, the regulatory evaluation,

any comments received, and other information. The street address for

any comments received, and other information. The street address for

the Docket Operations office (phone (800) 647-5527) is provided in the

ADDRESSES section. Comments will be available in the AD docket shortly

after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

List of Subjects in 14 CFR Part 39

reference, Safety.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator,

the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13 [Amended]

§ 39.13 [Amended]

2. The FAA amends § 39.13 by adding the following new AD:

2010-12-02 Turbomeca S.A.: Amendment 39-16323. Docket No. FAA-2009-

0982; Directorate Identifier 2009-NE-19-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective July 13,

2010.

Affected ADs

Affected ADs

(b) None.

Applicability

(c) This AD applies to Turbomeca S.A. Makila 1A and 1A1

turboshaft engines with a comparator/selector (CS) board, part

number (P/N) 0 177 99 716 0, and a serial number (S/N) between 241EL

and 1192EL (inclusive) installed. These engines are installed on,

but not limited to, Eurocopter AS 332 C, AS 332 C1, AS 332 L, and AS

but not limited to, Eurocopter AS 332 C, AS 332 C1, AS 332 L, and AS

332 L1 helicopters.

Reason

(d) The European Aviation Safety Agency (EASA) AD 2009-0090,

dated April 28, 2009, states that this AD results from the

following:

(1) The installation of TU250 CS boards, however, has resulted

in a few occurrences of erratic engine behaviour, in the form of

unexpected N1 variations and/or illumination of the "GOV" warning

unexpected N1 variations and/or illumination of the "GOV" warning

light. The conclusions from an investigation by Turboméca are

that these malfunctions are due to a lapse of quality control in the

varnishing process applied to the boards, and that only boards in a

specific serial number range, as defined under "Applicability" and

specific serial number range, as defined under "Applicability" and

referred to below as the "suspect batch", are affected.

(2) We are issuing this AD to prevent loss of automatic engine

control during flight due to an uncommanded engine roll-back, which

could result in the inability to continue safe flight.

Actions and Compliance

(e) Unless already done, do the following actions.

Actions and Compliance

(1) Within 50 operating hours from the effective date of this

AD, replace any CS board, P/N 0 177 99 716 0, with a S/N from 241EL

to 1192EL (inclusive), that has fewer than 200 hours-since-new

(HSN). Use paragraph 2 of Turbomeca S.A. Mandatory Service Bulletin

(MSB) No. 298 73 0809 Version A, dated February 12, 2008, to replace

(MSB) No. 298 73 0809 Version A, dated February 12, 2008, to replace

the boards.

(2) During the next 500-hour inspection, replace any CS board,

P/N 0 177 99 716 0, with a S/N from 241EL to 1192EL (inclusive),

that has 200 HSN or more. Use paragraph 2 of Turbomeca S.A. MSB No.

298 73 0810 Version B, dated April 27, 2009, to replace the boards.

FAA AD Differences

FAA AD Differences

(f) This AD differs from the Mandatory Continuing Airworthiness

Information (MCAI) and/or service information as follows:

(1) This AD requires replacing within 50 operating hours after

the effective date of this AD, all comparator/selector boards, P/N 0

177 99 716 0, with an S/N from 241EL to 1192EL (inclusive) that have

177 99 716 0, with an S/N from 241EL to 1192EL (inclusive) that have

fewer than 200 HSN.

(2) This AD requires replacing at the next 500-hour routine

inspection after the effective date of this AD, all comparator/

selector boards, P/N 0 177 99 716 0, with a S/N from 241EL to 1192EL

(inclusive) that have 200 HSN or more.

Alternative Methods of Compliance (AMOCS)

Alternative Methods of Compliance (AMOCS)

(g) The Manager, Engine Certification Office, FAA, has the

authority to approve AMOCs for this AD, if requested using the

procedures found in 14 CFR 39.19.

Related Information

(h) Refer to MCAI EASA Airworthiness Directive 2009-0090, dated

April 28, 2009, for related information.

Related Information

(i) Contact Kevin Dickert, Aerospace Engineer, Engine

Certification Office, FAA, Engine and Propeller Directorate, 12 New

England Executive Park, Burlington, MA 01803; e-mail:

[email protected]; telephone (781) 238-7117, fax (781) 238-7199,

for more information about this AD.

Material Incorporated by Reference

Material Incorporated by Reference

(j) You must use the service information specified in Table 1 of

this AD to do the actions required by this AD, unless the AD

specifies otherwise.

(1) The Director of the Federal Register approved the

incorporation by reference of this service information under 5

incorporation by reference of this service information under 5

U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact

Turbomeca, 40220 Tarnos, France; telephone 33 05 59 74 40 00; fax 33

05 59 74 45 15.

(3) You may review copies at the FAA, New England Region, 12 New

England Executive Park, Burlington, MA; or at the National Archives

and Records Administration (NARA). For information on the

and Records Administration (NARA). For information on the

availability of this material at NARA, call (202) 741-6030, or go

to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Table 1--Material Incorporated by Reference

Turbomeca mandatory Service Bulletin

No. Page Version Date

Turbomeca mandatory Service Bulletin

298 73 0809 …

Total Pages: 7 ALL … A February 12, 2008.

298 73 0810 …

Total Pages: 7 ALL … B April 27, 2009.

Issued in Burlington, Massachusetts, on May 24, 2010.

Peter A. White,

Assistant Manager, Engine and Propeller Directorate, Aircraft

Certification Service.