Radar Vectors
Airworthiness Directive Superseded Issued Feb 27, 2006 3 pages Copy saved Nov 17, 2026

AD 2006-04-15 Turbomeca Artouste III B, Artouste III B1, and Artouste III D Turboshaft Engines

The FAA is adopting a new airworthiness directive (AD) for Turbomeca Artouste III B, Artouste III B1, and Artouste III D turboshaft engines. This AD requires removing certain fuel pumps from service and installing serviceable fuel pumps. This AD results from a report that an acceptance test facility used test equipment that was out of calibration, on certain fuel pumps, and those fuel pumps might have been accepted with a limitation in the maximum available fuel flow. We are issuing this AD to prevent reduced helicopter performance, subsequent loss of control of the helicopter, or accident.

This document is no longer current. Superseded by AD 2007-19-11. Check the official source before relying on it.

Official source ↗ Official PDF ↗

14 CFR Part 39

[Docket No. FAA-2006-23594; Directorate Identifier 2005-NE-54-AD; Amendment 39-14497; AD 2006-04-15] RIN 2120-AA64

Airworthiness Directives; Turbomeca Artouste III B, Artouste III B1, and Artouste III D Turboshaft Engines

AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).

Action

ACTION: Final rule; request for comments.

SUMMARY: The FAA is adopting a new airworthiness directive (AD) for Turbomeca Artouste III B, Artouste III B1, and Artouste III D turboshaft engines. This AD requires removing certain fuel pumps from service and installing serviceable fuel pumps. This AD results from a report that an acceptance test facility used test equipment that was out of calibration, on certain fuel pumps, and those fuel pumps might have been accepted with a limitation in the maximum available fuel flow. We are issuing this AD to prevent reduced helicopter performance, subsequent loss of control of the helicopter, or accident.

Dates

DATES: Effective March 14, 2006.

We must receive any comments on this AD by April 28, 2006.

ADDRESSES: Use one of the following addresses to comment on this AD:

• DOT Docket Web site: Go to http://dms.dot.gov and follow the instructions for sending your comments electronically.

• Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.

Addresses

• Mail: Docket Management Facility; U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC 20590-0001.

• Fax: (202) 493-2251.

• Hand Delivery: Room PL-401 on the plaza level of the Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

Contact Turbomeca, 40220 Tarnos, France; telephone +33 05 59 74 40 00, fax +33 05 59 74 45 15, for the service information identified in this AD.

For Further Information Contact

FOR FURTHER INFORMATION CONTACT: Christopher Spinney, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803-5299; telephone (781) 238-7175; fax (781) 238-7199.

SUPPLEMENTARY INFORMATION: The Direction Generale de L'Aviation Civile (DGAC), which is the airworthiness authority for France, notified the FAA that an unsafe condition may exist on Turbomeca Artouste III B, Artouste III B1, and Artouste III D turboshaft engines. The DGAC advises that an acceptance test facility used test equipment that was out of calibration, on 102 fuel pumps, and those fuel pumps might have been accepted with a limitation in the maximum available fuel flow. This condition causes fuel flow limitation and therefore reduces the maximum available engine power over a portion of the helicopter flight envelope. These pumps may be installed on Eurocopter France Alouette III SE.3160, SA.316B, SA.315B, and SA.316C helicopters registered in the U.S. Turbomeca issued Mandatory Service Bulletin No. 218 73 0802, dated November 17, 2005, to address the 102 suspect fuel pumps. We cannot confirm that these fuel pumps have been removed from service and retested or replaced. The DGAC issued AD No. F-2005-201, dated December 7, 2005, in order to ensure the airworthiness of these engines in France.

Bilateral Airworthiness Agreement

Bilateral Airworthiness Agreement

These Turbomeca Artouste III series turboshaft engines are manufactured in France and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Under this bilateral airworthiness agreement, the DGAC kept the FAA informed of the situation described above. We have examined the findings of the DGAC, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.

FAA's Determination and Requirements of This AD

FAA's Determination and Requirements of This AD

The unsafe condition described previously is likely to exist or develop on other Turbomeca Artouste III B, Artouste III B1, and Artouste III D turboshaft engines of the same type design. We are issuing this AD to prevent reduced helicopter performance, subsequent loss of control of the helicopter, or accident. This AD requires removing affected fuel pumps from service and installing serviceable fuel pumps, within 30 days or 80 operating hours after receipt of a serviceable fuel pump, whichever occurs first, but no later than March 15, 2006.

FAA's Determination of the Effective Date

FAA's Determination of the Effective Date

Since an unsafe condition exists that requires the immediate adoption of this AD, we have found that notice and opportunity for public comment before issuing this AD are impracticable, and that good cause exists for making this amendment effective within 30 days.

Comments Invited

Comments Invited

This AD is a final rule that involves requirements affecting flight safety and was not preceded by notice and an opportunity for public comment; however, we invite you to send us any written relevant data, views, or arguments regarding this AD. Send your comments to an address listed under ADDRESSES. Include "AD Docket No. FAA-2006-23594; Directorate Identifier 2005-NE-54-AD" in the subject line of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify it.

We will post all comments we receive, without change, to http://dms.dot.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this AD. Using the search function of the DMS Web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78) or you may visit http://dms.dot.gov.

Examining the AD Docket

Examining the AD Docket

You may examine the docket that contains the AD, any comments received, and any final disposition in person at the Docket Management Facility Docket Office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Office (telephone (800) 647-5227) is located on the plaza level of the Department of Transportation Nassif Building at the street address stated in ADDRESSES. Comments will be available in the AD docket shortly after the DMS receives them.

Authority for This Rulemaking

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in subtitle VII, part A, subpart III, section 44701, "General requirements." Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

Regulatory Findings

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that the regulation:

1. Is not a "significant regulatory action" under Executive Order 12866;

2. Is not a "significant rule" under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a summary of the costs to comply with this AD and placed it in the AD Docket. You may get a copy of this summary by sending a request to us at the address listed under ADDRESSES.

List of Subjects in 14 CFR Part 39

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

Under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13 [Amended]

2. The FAA amends § 39.13 by adding the following new airworthiness directive:

2006-04-15 Turbomeca: Amendment 39-14497. Docket No. FAA-2006-23594; Directorate Identifier 2005-NE-54-AD.

Effective Date

Effective Date

(a) This airworthiness directive (AD) becomes effective March 14, 2006.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Turbomeca Artouste III B, Artouste III B1, and Artouste III D turboshaft engines. These engines are installed on, but not limited to, Eurocopter France Alouette III SE.3160, SA.316B, SA.315B, and SA.316C helicopters.

Unsafe Condition

Unsafe Condition

(d) This AD results from a report that an acceptance test facility used test equipment that was out of calibration, on certain fuel pumps, and those fuel pumps might have been accepted with a limitation in the maximum available fuel flow. We are issuing this AD to prevent reduced helicopter performance, subsequent loss of control of the helicopter, or accident.

Compliance

Compliance

(e) You are responsible for having the actions required by this AD performed within 30 days or 80 operating hours after the receipt of a serviceable fuel pump, whichever occurs first, but no later than March 15, 2006, unless the actions have already been done.

(f) Remove from service the fuel pumps listed by serial number (SN) in the following Table 1, and install a serviceable fuel pump.

Table 1.--Affected Fuel Pump SNs

A59B F504B 2827

A82B F506B 2828

A91B F537B 2830

B14B F561B 2838

B29B F589B 2854

B42B F596B 2867

C27B F607B 2868

C6B F630B 2884

C92B F643B 2944

D16B F706B 3078

D18B F724B 3175

D20B F743B 3230

D80B F745B 3259

D99B F748B 3282

E49B F759B 3343

E77B F760B 3376

E90B F762B 3383

F112B F957B 3385

F131B 808 3397

F176B 1725 3458

F220B 1766 3515

F243B 1770 3548

F253B 1897 3660

F262B 1941 3746

F293B 2154 3756

F317B 2155 3757

F320B 2233 3783

F357B 2512 3792

F368B 2620 3826

F420B 2729 3858

F464B 2759 3888

F466B 2763 3894

F477B 2786 3979

F47B 2787 4066

Definition

Definition

(g) For the purpose of this AD, a serviceable fuel pump is:

(1) A fuel pump that is not listed in Table 1 of this AD; or

(2) A fuel pump that is listed in Table 1 of this AD that has passed a repeat of the original production acceptance test.

Alternative Methods of Compliance

Alternative Methods of Compliance

(h) The Manager, Engine Certification Office, has the authority to approve alternative methods of compliance for this AD if requested using the procedures found in 14 CFR 39.19.

Related Information

(i) Direction Generale de L'Aviation Civile AD No. F-2005-201, dated December 7, 2005, also addresses the subject of this AD.

Related Information

(j) Turbomeca Mandatory Service Bulletin No. 218 73 0802, dated November 17, 2005, pertains to the subject of this AD.

Issued in Burlington, Massachusetts, on February 17, 2006. Peter A. White, Acting Manager, Engine and Propeller Directorate, Aircraft Certification Service.