Radar Vectors
Airworthiness Directive Superseded Issued Jul 31, 2000 3 pages Copy saved Nov 17, 2026

AD 2000-14-51 Air Tractor, Inc. Models AT-501, AT-502, and AT-502A Airplanes

This document publishes in the Federal Register an amendment adopting emergency Airworthiness Directive (AD) 2000-14-51. The Federal Aviation Administration (FAA) previously sent emergency AD 2000-14-51 to all known U.S. owners and operators of Air Tractor Models AT-501, AT-502, and AT-502A airplanes. This AD requires you to inspect the wing lower spar cap for cracks and modify or replace any cracked lower spar cap. This AD is the result of an accident report of an Air Tractor Model AT-502A airplane where the wing separated in flight. The actions specified by this AD are intended to detect and correct fatigue cracks in the wing lower spar cap, which could result in an in-flight separation of the wing from the airplane.

This document is no longer current. Superseded by AD 2001-10-04. Check the official source before relying on it.

The FAA first issued this AD as an emergency AD on Jul 3, 2000. Emergency AD in DRS ↗

Official source ↗ Official PDF ↗

and Regulations DEPARTMENT OF TRANSPORTATION

14 CFR Part 39

[Docket No. 2000-CE-40-AD; Amendment 39-11837; AD 2000-14-51] RIN 2120-AA64

Airworthiness Directives; Air Tractor, Inc. Models AT-501, AT-502, and AT-502A Airplanes

ACTION: Final rule; request for comments.

SUMMARY: This document publishes in the Federal Register an amendment adopting emergency Airworthiness Directive (AD) 2000-14-51. The Federal Aviation Administration (FAA) previously sent emergency AD 2000-14-51 to all known U.S. owners and operators of Air Tractor Models AT-501, AT-502, and AT-502A airplanes. This AD requires you to inspect the wing lower spar cap for cracks and modify or replace any cracked lower spar cap. This AD is the result of an accident report of an Air Tractor Model AT-502A airplane where the wing separated in flight. The actions specified by this AD are intended to detect and correct fatigue cracks in the wing lower spar cap, which could result in an in-flight separation of the wing from the airplane.

Dates

DATES: The AD becomes effective August 4, 2000, to all affected persons who did not receive emergency AD 2000-14-51, issued July 3, 2000. Emergency AD 2000-14-51 contained the requirements of this amendment and became effective immediately upon receipt.

The Director of the Federal Register approved the incorporation by reference of certain publications listed in the regulation as of August 4, 2000.

The FAA must receive any comments on this rule on or before September 15, 2000.

Addresses

ADDRESSES: Submit comments in triplicate to FAA, Central Region, Office of the Regional Counsel, Attention: Rules Docket No. 2000-CE-40-AD, 901 Locust, Room 506, Kansas City, Missouri 64106. You may read comments and information related to this AD at this location between 8 a.m. and 4 p.m., Monday through Friday, except holidays.

You may get the service information referenced in this AD from Air Tractor, Incorporated, P.O. Box 485, Olney, Texas 76374. You may examine this information at FAA, Central Region, Office of the Regional Counsel, Attention: Rules Docket No. 2000-CE-40-AD, 901 Locust, Room 506, Kansas City, Missouri 64106; or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

For Further Information Contact

FOR FURTHER INFORMATION CONTACT: Rob Romero, Aerospace Engineer, FAA, Fort Worth ACO, 2601 Meacham Boulevard, Fort Worth, Texas 76193-0150; telephone: (817) 222-5102; facsimile: (817) 222-5960.

SUPPLEMENTARY INFORMATION:

Discussion

What Has Happened So Far?

The FAA has received a report of an accident of an Air Tractor Model AT-502A airplane where the wing separated in flight. Investigation revealed that the wing lower spar cap was cracked at the wing center splice connection. We surveyed the Air Tractor Models AT-501, AT-502, and AT-502A airplane fleet and discovered 2 other airplanes that have had similar cracks in the lower spar caps.

What Has Happened So Far?

On July 3, 2000, we issued emergency AD 2000-14-51. This AD directed the following:

--Repetitively inspect each wing lower spar cap for cracks; and --Modify or replace any cracked lower spar cap, as specified in the service information.

Accomplishment of this action is required in accordance with the procedures in Snow Engineering Co. Service Letter #197, dated June 13, 2000.

Why Is It Important To Publish This AD?

Why Is It Important To Publish This AD?

The FAA found that immediate corrective action was required, notice and opportunity for prior public comment were impracticable and contrary to the public interest, and good cause existed to make the AD effective immediately by individual letters issued on July 3, 2000, to all known U.S. operators of Air Tractor, Inc. Models AT-501, AT-502, and AT-502A airplanes. These conditions still exist, and the AD is published in the Federal Register as an amendment to section 39.13 of the Federal Aviation Regulations (14 CFR 39.13) to make it effective as to all persons.

Comments Invited

Comments Invited

How Do I Comment on This AD?

Although this action is in the form of a final rule and was not preceded by notice and opportunity for public comment, FAA invites comments on this rule. You may submit whatever written data, views, or arguments you choose. You need to include the rule's docket number and submit your comments in triplicate to the address specified under the caption ADDRESSES. We will consider all comments received on or before the closing date specified above. We may amend this rule in light of comments received.

How Can We Communicate More Clearly With You?

How Can We Communicate More Clearly With You?

The FAA is reviewing the writing style we currently use in regulatory documents, in response to the Presidential memorandum of June 1, 1998. That memorandum requires federal agencies to communicate more clearly with the public. We are interested in your comments on the ease of understanding this document, and any other suggestions you might have to improve the clarity of FAA communications that affect you. You can get more information about the Presidential memorandum and the plain language initiative at http://www.faa.gov/language/.

The FAA specifically invites comments on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. You may examine all comments we receive in the Rules Docket. We will file a report in the Rules Docket that summarizes each FAA contact with the public that concerns the substantive parts of this AD.

How Can I Be Sure the FAA Receives My Comment?

How Can I Be Sure the FAA Receives My Comment?

If you want us to acknowledge the receipt of your comments, you must include a self-addressed, stamped postcard. On the postcard, write "Comments to Docket No. 2000-CE-40-AD." We will date stamp and mail the postcard back to you.

Regulatory Impact

How Does This AD Impact Relations Between Federal and State governments?

How Does This AD Impact Relations Between Federal and State governments?

These regulations will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. The FAA has determined that this final rule does not have federalism implications under Executive Order 13132.

How Does This Action Involve an Emergency Situation?

How Does This Action Involve an Emergency Situation?

The FAA determined that this is an emergency regulation that must be issued immediately to correct an unsafe condition in aircraft, and is not a significant regulatory action under Executive Order 12866. This action involves an emergency regulation under Department of Transportation (DOT) Regulatory Policies and Procedures (44 FR 11034, February 26, 1979). The FAA will prepare a final regulatory evaluation if we determine that this emergency regulation is significant under DOT Regulatory Policies and Procedures. You may obtain a copy of the evaluation (if required) from the Rules Docket.

List of Subjects in 14 CFR Part 39

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Under the authority delegated to me by the Administrator, the Federal Aviation Administration (FAA) amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13 [Amended]

2. FAA amends Section 39.13 by adding a new airworthiness directive (AD) to read as follows:

2000-14-51 Air Tractor Incorporated: Amendment 39-11837; Docket No. 2000-CE-40-AD.

§ 39.13 [Amended]

(a) What airplanes are affected by this AD? This AD applies to the following Air Tractor airplane models and serial numbers:

Model Serial numbers

AT-501 … 501-002 through 501-0060 that have been converted

to turboprop power.

AT-502 … 502-003 through 502-0061, except those that have

been upgraded to the 8,000-pound gross weight

configuration through the incorporation of Snow

Engineering Co. Service Letter #80J.

AT-502A … All serial numbers.

(b) Who must comply with this AD? Anyone who wishes to operate any of the above airplanes on the U.S. Register must comply with this AD.

(c) What problem does this AD address? This AD is intended to detect and correct fatigue cracks in the wing lower spar cap, which could result in an in-flight separation of the wing from the airplane.

(d) What actions must I accomplish to address this problem? To address this problem, you must accomplish the following:

Action When Procedures

(1) Initial Inspection: At whichever of the Accomplish this

Visually inspect the wing following that is inspection in

lower spar cap at the wing applicable: accordance with the

center splice connection (i) For the Models Inspection

for cracks. AT-501 and AT-502 Requirements

airplanes: Upon section of Snow

accumulating 4,000 Engineering Co.

hours time-in- Service Letter

service (TIS) on #197, dated June

each wing or within 13, 2000.

the next 10 hours

TIS after the

effective date of

this AD, whichever

occurs later; or.

(ii) For the Model

AT-502A airplanes:

Upon accumulating

3,000 hours TIS on

each wing or within

the next 10 hours

TIS after the

effective date of

this AD, whichever

occurs later.

(2) Repetitive Inspections: For all affected Accomplish these

Inspect using visual or airplanes, inspections in

ultrasonic methods the wing accomplish the accordance with the

lower spar cap at center repetitive Inspection

splice connection for inspections as Requirements

cracks. follows: section of Snow

(i) Visually: Within Engineering Co. the

50 hours TIS after Service Letter

the initial #197, dated June

inspection and 13, 2000.

thereafter at

intervals not to

exceed 50 hours

TIS; or.

(ii) Using

ultrasonic methods:

Within 400 hours

TIS after the

initial inspection

and thereafter at

intervals not to

exceed 400 hours

TIS.

(3) Replace or modify any Prior to further Accomplish the

cracked wing lower spar flight after the replacement and

cap, as specified in the inspection where modification as

service information. the crack is found. follows:

(i) Replacement:

Remove the wing

with the cracked

lower spar cap and

return to Air

Tractor for spar

cap replacement.

Immediately notify

Air Tractor that

you are sending the

wing if the cracked

spar cap can not be

modified.

(ii) Modification:

In accordance with

the TERMINATING

ACTION section of

Snow Engineering

Co. Service Letter

#197, dated June

13, 2000.

(4) Modifying each lower This terminating Accomplish in

spar cap is considered action may be accordance with the

terminating action for the accomplished at any TERMINATING ACTION

repetitive inspection time provided the section of Snow

requirement. This lower spar caps are Engineering Co.

modification can only be not cracked. Service Letter

accomplished if the lower #197, dated June

spar caps are inspected 13, 2000.

before the modification is incorporated and: (i) no cracks are found; or (ii) any crack found can be removed by drilling the hole to the next larger size.

(e) Can I comply with this AD in any other way? You may use an alternative method of compliance or adjust the compliance time if:

(1) Your alternative method of compliance provides an equivalent level of safety; and

(2) The Manager, Fort Worth Airplane Certification Office (ACO), approves your alternative. Submit your request through an FAA Principal Maintenance Inspector. The inspector may add comments before sending it to the Manager, Fort Worth ACO.

Note: This AD applies to each airplane identified in paragraph (a) of this AD, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/ operator must request approval for an alternative method of compliance in accordance with paragraph (e) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if you have not eliminated the unsafe condition, specific actions you propose to address it.

(f) Where can I get information about any already-approved alternative methods of compliance? Contact Rob Romero, Aerospace Engineer, FAA, Fort Worth ACO, 2601 Meacham Boulevard, Fort Worth, Texas 76193-0150; telephone: (817) 222-5102; facsimile: (817) 222-5960.

(g) What if I need to fly the airplane to another location to comply with this AD? The FAA can issue a special flight permit under sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate your airplane to a location where you can accomplish the requirements of this AD provided you comply with the following:

(1) The hopper is empty;

(2) Vne is reduced to 138 miles per hour (mph) (120 knots) indicated airspeed (IAS); and

(3) Flight into known turbulence is prohibited.

(h) Are any service bulletins incorporated into this AD by reference? Actions required by this AD must be done in accordance with Snow Engineering Co. Service Letter #197, dated June 13, 2000. The Director of the Federal Register approved this incorporation by reference under 5 U.S.C. 552(a) and 1 CFR part 51. You may get copies of this document from Air Tractor, Incorporated, P.O. Box 485, Olney, Texas 76374. You may look at copies at FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

(i) When does this AD become effective? This AD becomes effective August 4, 2000, to all affected persons who did not receive emergency AD 2000-14-51, issued July 3, 2000. Emergency AD 2000-14-51 contained the requirements of this amendment and became effective immediately upon receipt.

Issued in Kansas City, Missouri, on July 20, 2000. Marvin R. Nuss, Acting Manager, Small Airplane Directorate, Aircraft Certification Service.