Radar Vectors
Advisory Circular Current Issued Jun 19, 1990 AFS-200 5 pages Copy saved Nov 18, 2026

AC 121.195-1A Operational Landing Distances for Wet Runways; Transport Category Airplanes

This advisory circular {AC) sets forth an acceptable means, but not the only means, of showing compliance with Federal Aviation Regulations (FAR) § 121.195 (d) pertaining to operational landing distances on wet runways. It is for guidance purposes and provides an example of method of compliance that has been found acceptable.

Official source ↗ Open PDF

.Deponn ient of lronsportofiOn F«ttral Aviation Administration

Advisory Circular

Subject: OPERATIONAL LANDING DISTANCES Dace: 6/19/90 AFS-430

AC No: 121.195 - Ou&e: FOR WET RUNWAY$ i TRANSPORT CATEGORYlnidlled by: AIRPLANES ..

1. PURPOSE. This advisory ci rcutar {AC) sets forth an acceptable 11eans, but not the only 11eans, of showing co111p1iance with Feder.al Aviation R.e;ulations

{FARJ § 121.195 Cd) pertaining to operational landing distances on wet runways. It is for guidance purposes and provides an example of n nthod of coapliance that has been found acceptable.

2.. CANCELLATION. Advisory Circular l21.t95{dl-1, dated 11/19/65, is cancelled.

3. RELATED FAR . SECTION$ .

a. FAR § 121.195(d}.

b. FAR§ 25.125.

4. RELATED READING MATERIAL.

a. Advisory Circular 91-6A, Water, Slush, and Snow on the Runway.

b. Advisory Circular 150/5320-12A, Measute111ent, Construction, and Maintenance of Skid Resistant Airport Pavement Surfaces.

c. Advisory Circular 25-7. Flight Test Guide for Certification of Transport Category Airplanes.

5 . BACKGROUND.

a. In determining safe operational runway lengths that provide for operational variables not included in type certification tests, FAR§ 121.195(1:>) requires a runway length adequate to allow a fu11-stop landing (based on the type certification tests) within 60 percent of the effective length of the runway. The operational variables include runway surface conditions. piloting techniques. tire an<i btalte deterioration, at11ospberic instability such as gusts or windshear. crosswinds, approach to touchdown, flightpath deviations. and others. FAR § 121.195(d) requires an addi tion11L 15 percent runway lenath for operations into wet or slippery runways.

b. As an alternative to the additional 15 percent runway leneth requirement, FAR § 121.195(d) allows operational wet runway distances to be used

if they ue based "on a showing of ectual operating landing techniques on wet runways." However, this alternative distance can never be less than the factored dry runway distances required by FAR§ 121.195(b).

FAA Form 1320-15 (4-82) Superaeaes WA Form 1~2

-1A

121.195 6/19/90

c. N'oraally the operating enviTon•ental condition associated with a wet runway is an Instruaent Flhbt Rules condition requiring an instruaent approach. Other factors pertinent to successful wet runway operations include runway surface aaintenance, 1linia1111 Equipaent List (MEL) control of iteas related to stopping pedoTaance, weather reportin2. and tli1btcrew procedures and training. The objective o.f the 1uidance aater.ial in this AC is to ensure that critical variables associated with actual inservice wet runway perforaanca are considered to the degree that any approvals in accordance with the alternative provision of FAR I 12Ll95(d) are appropri1ltely conservative.

6. ACCEPTABLE KEAMS OF ESTABLISHlNG OPERATIONAL LANDI.MG DISTANCES ON WET RUNWAYS. An acceptable aetbod of obtaining approval undeT FAR I 121.19S(d) is to establish landing field lengths subject to the following:

a. Flight Test Requiuaents.

(1} Testing should be conducted on the runway for which approval .is being sought, or a runway that is shown to be equivalent. Data to be used in aaking an equive.lency finding should be coordinated with the Federal Aviation Adainistration, Northwest Mountain Region. Transport Airplane Directorate

(ANM-100), 17900 Pacific Highway South, C-68966, Seattle, Washington 98168.

. • (2) For new aodels, or where additional data ere required for existing aodels, tests aust be conducted.

b. Flight Test Conditions.

(1) Tbe bnking coefficient of friction obtained fro• not lass than six landing tests conducted in nccordance with FA.R 5 25.125 and subject to the additional provisions listed below should be used to establish the ground braking distances.

(i} The landine should be preceded by a stabilized approach not to exceed an angle of 3° down to the 50-foot height and at a calibrated airspeed not less than 1.4 Vso·

(ii) The avera2e touchdown rate of descent should not e,cceed 6 feet per second. Loneitudinal control a11d bralte application proceclur~s •ust be such that they can be consistently •ppliecl to yield a nose geet touchdown rate of descent that does not exceed 8 feet per second.

(iii} The runway should be lev•l, saootb, hard-surfaced, and well-soaked, (Areas of aeasuroble water depth are acceptable for testina.J

(2) The wheels should be fitted with th-es t.hat are worn to a point where no aote than 20 percent of the original tread depth reaains. Tires aay be changed between tests provided they ue within specified liaits.

2 Par 5

2 Par 5

f

AC 121.195

(.3) The aain lending gee:t tire pnssure should be set to not less than the aaxiaua pressure corresponding to the actual test weight.

c. Airplane Flight Manuol.

(1) Airplane Flight Nnnual (AFM) distances should l>e established that represent .. the distance traversed froa the SO-foot height to full stop, subject to the following:

(i} Airborne distance fro• the 50 ... foot hei1bt to touchdown should be calculated based on a tiae incre•ent of 7 seconds or the air tiae certificated under FAR I 25.125 plus an additional 2 seconds, whichever is greater; e speed at the SO-foot height of t.4 Vso; and a speed at touchdown calculated fro• the ratio Vn/V-50 • 0.96. :Note: It is not intended that the actual operational approach speed be altered for approval under this AC.

{ii) Transition distance fro• touchdown to the point where all approved deceleration devices are operative should be calculated based on the speed at touchdown froa paragraph 6cl1)(i) and on the tiae iocreaent and speed ratio certificated under FAR§ 25.125.

(iii} Ground braltin2 distance in the approved deceleration configuration should be based on the braking coefficient of friction deterMined under paragra.gb 6b and the deceleration parameters certificated under FAR 5 25.125. Credit for reverse thrust will not be Riven.

{iv) Distances established in ac.cordance with paragraphs 6cU) (i}. (ii}, and (iii} should be increased by a factoT to assure operational safety. Multi.plying tbe basic distances by 1.15 is considered appropriate for this purpose .

{v) The distances established under the criteria in this AC aust not be less than the distances dEl'terained under FAR S 121.19S(b}.

(2) Operational landing distances in accordance with this AC that account for the operational va1:iables listed under the discussion of FAR§ 2S.12S in AC 25-7 aust be aade available in th~ perforaance inforaation section of the AFM.

(3) the AFM should contain a stateaent to the effect that: "The landine perforaance of this airplane has been .~valuated i-n accordance with AC l21.19S{d)-1A and found suitable for the ru.nways specified in the following

list. This finding does not constitute operational ai,proval to base the landing perforaance tequireaeuts on these distances."

7. FAR PAllT .121 OPERA'l'IONAL APPROVALS OF AIRCRAFT .WITH .OPERATIONAL LANDING PERFORMANCE DATA ON WET RUNWAYS.

a. Operators aay apply to use wet rUllway operational perforaance data deter11ined in accordance with this AC under the prodsions of FAR f 12.1.195.

Par 6 3

.:. ..,:.·_,__

AC 121.195 6/19/90

The operations may be approved by issuance of operations specifications under

Part C by listing the provisions and limitations which must be •et for eaeb runway where this perforaance is approved. Operation$ specifications should be coordinated with the Federal Aviation Adainistration, Technical Progrruns Division {AFS-400}, Flight Standards Service, 800 Independence Avenue, SR., Washington, DC 20591, prior to issuance.

b. Eligibility. To··be eligible for approval in Part C of the ope.rations specifications., the runway aust:

(1} Be the ruttway the fli1ht testing of paragraph 6 was conducted on, or a runway shown to have equivalent wet surface braking characteristics, or a runway that is grooved or porous friction course overlayed.

(2) Be maintained under an approved program equivalent to the criteria in AC 150/5320-12A which is acceptable to the Federal Aviation Administration Flight Standards Service. For foreign airports. an agreement should be obtained between the operator and the airport operator specifying the equivalent minimum

level of runway surface •aintenance to be accomplished. These agreements should specify the inspection frequency. aaintenance frequency. and notification to the operator if the required friction levels cannot be maintained.

{3) Be equipped with serviceable runway and touchdown markings'tOr ., daytime operations and serviceable lighting systems if night operations are authorized. Either an approved approach path indicator (such as a Visual Approach Slope Indicator or Precision Approach Path Indicator} or an electronic glidepath which provides an acceptable threshold crossing height for the aircraft used should be installed and serviceable.

e. Training and Currency. The operators' approved training programs and operating manuals should address the following factors:

(1) The approved training and qualification program should specify those requirements necessary to assure that flightcrews and dispatchers are cognizant of the visual aid, MEL, and aircraft configuration requirements. for operations on operational performance runways. These training and qualification requirements should also assure that fligbtcrews and dispatchers are cognizant of the runways where operational perforaance is authorized.

(2) The required aircraft confieuration should be specified in the ope1:ating manuals to include the allowable flap settings. other necessary configuration requirements (such as limits on en2ine-out approaches). and pertinent MEL items such as windshield wipers. thrust reversers, antiskid systems. etc.

{3} Pilots in co111111and should not be approved for these operations if they have less than 100 hours as pilot in co .. and in the airplane type being used.

4 Par 7

4 Par 7

~-

AC 121.195

(4) Unless Phase II approved siaulators with 4pproved visual aodels tor the operational perforaance runways are used, actua1 landings using the operational perforaance techniques should be accoaplished by each pilot prior to conducting line operations at these runways. Each pilot authorized to perfor• the landing using special operational perforaance aust have coapleted at least one landing (actual or siaulated) on the authorized operational perforaance runways within the last 90 days in each type of aircraft authorized to use the special operati6na1 perforaance. Special perforaance landing currency aay be reestah1isbed in an approved siau1ator or by COilpleting a line check.

d. Weather. Operations using special opetational petforaance should not be conducted on any runway unless the following special weather require•ents can be •et:

(1} Windsbear or Thunderstor•s. There should be no significant windsbear or thunderstoras which affect the use of the special performance runway(s), ·such as:

{i) Significant windshear reported by a Low Level Windshear Alert Systea, or

(ii} Pilot reports of significant windsheat, or

(iii) Thunderstor•s observed or reported within 5 nautical Miles of the final approach path or the •issed approach path for the operational perforaance runway beine used.

(2.) Visibility/RVR/RVV. The reported visibility/Runway Visual Range (RVR)/Runway Visibility Value (RVV} for the operational perforaance runway being used shall not be less than 1 statute •ile (RVR 5000).

(3) Winds. The crosswind coaponent (including gust values) aust not exceed 15 knots and tailwind eoaponents aust not exceed O knots.

e. Runway Braking Effectiveness. There should be no snow, slush, ice, frost. or standing water {other than isolated patches which do not iapact braking effectiveness) observed oT reported on the special operational perforaance runway within the •idth necessary for safe operations. Braking effectiveness aust be at least •goodft (e.g., not •fair,• •poor,• or •nit•) and

there shall be no current reports of hydroplaning or slippery runway surfaces.

-:U~cc,..,..._~ Daniel c. Beaudette Director, Flight Stanaards Service

Par 7 5